: BONSAI INFO

Before you start, remove your tree from the starter kit. Study the tree to decide which style you would like and best compliments your tree. Traditionally bonsai are designed in an asymmetrical triangle, the lowest point symbolizes earth, the middle is man and the highest point is heaven.

Remove your tree from the Bonsai Garden box. Keeping mind the style you have selected, trim away the unwanted foliage. Trim the branches as near flush with the trunk as possible. We also recommend that the foliage be removed from the underside of each branch. Foliage should not be so thick as to obscure the branches, trunk, and general design of your tree.

To wire, anchor the end of the wire in the soil, pushing it down to the bottom of the container. Start the wire in the back of the trunk and wrap diagonally up the trunk and out the branch to be trained. This can be done on a limb only if you prefer, simply start the wire at the base of the branch and continue to the tip. Wrap the wire snug, but not tight your tree will need room to grow.

Remove the bonsai container, pebbles, and soil mixture from the Bonsai Garden box. Place the container in front of you and fill with enough pebbles to cover the bottom of the container (approx. 1/4"). Save the remaining pebbles to decorate the surface of your tree. Next remove your tree from its plastic container. Gently loosen soil roots with your fingers. Try not to disturb the soil at the center of the root mass. It is especially important not to damage the fine feeder roots, these roots are what gather your trees' food and water.

Place your tree in the container to best visualize its permanent placement. Spread the roots along the container in a loose comfortable manner, any roots that extend over the edge of the container should be trimmed away.

Your trees should extend slightly above the edge of the container. To achieve this it may be necessary to add a thin layer of the soil mixture over the pebbles. Place the fertilizer briquette in one corner of the container and begin to fill the container with the soil. Use your fingers to pack the soil firmly into the container. Upon completion the soil should be level or slightly below the top of the container.

Water you new bonsai tree very carefully. Use a misting bottle and water slowly until the water starts to drip through the drainage holes in the bottom of the container.

To decorate your bonsai, place the moss provided in water for a few moments to soften. The moss should then be placed on the surface of soil around your tree. Press gently to hold in place. The moss should cover from 1/2 to 3/4 of the surface leaving enough room at the edge to sprinkle the remaining pebbles.